Spin Master Motorized Toy Car 43020 User Manual

®
MOTOCROSS  
Congratulations! You are the proud owner of the AIR HOGS®  
Motocross Bike. Your AIR HOGS® Motocross Bike can travel  
distances of up to 120 feet and race at scale speeds of up to  
150MPH (1:9 Scale). Your bike is also equipped with a  
wheelie bar, so you can perform pop-a-wheelies!  
PLEASE READ THESE INSTRUCTIONS BEFORE USE!  
PROBLEMS? PLEASE DO NOT TAKE YOUR  
AIR HOGS® MOTOCROSS BIKE BACK TO THE STORE!  
CALL SPIN MASTER TOLL FREE AT:  
IMPORTANT  
1-800-622-8339  
A. SELECTING YOUR LOCATION:  
D. PERFORMING A  
The Air Hogs® Motocross Bike performs best on  
POP-A-WHEELIE:  
1. Pressurize your bike’s engine, as explained  
FLAT SMOOTH SURFACES, free of bumps and other  
obstructions. Do not play on harsh or rocky surfaces.  
Do not play on or near roadways. Always consult  
your guardian before playing to ensure the area in  
which you would like to play is clear and safe!  
in section B.  
2. Lower the wheelie bar into place, as shown (d).  
d
B. PRESSURING THE ENGINE:  
1. BEFORE PUMPING, ROTATE THE REAR TIRE UNTIL  
THE PISTON IS SET AT THE FRONT OF THE PISTON  
WINDOW (see CORRECT drawing).  
IF THE PISTON IS AT THE BACK OF THE PISTON  
WINDOW, THE AIR WILL LEAK OUT OF THE BIKE  
DURING PUMPING! (see INCORRECT drawing).  
e
2. Attach the bike to the pump, as shown (a).  
3. Place the bike on a  
3. Lay bike on its side, as shown (b).  
smooth flat surface.  
4. Place one foot on each side of the pump base and  
grasp the pump handle with both hands (b).  
5. Pump air into the bike.  
4. Raise the front end of  
the bike into the air so  
that only the rear  
6. Push button to unlock pump clip and remove bike from pump.  
wheel and the wheelie  
bar are resting on the  
ground (e).  
PISTON  
PISTON  
5.Give your bike a firm  
push in the direction  
you want to go,  
f
PISTON  
PISTON  
AT FRONT  
AT BACK  
remembering to guide  
the bike with your  
hand for1-2 feet before  
releasing,as explained  
above (f).  
INCORRECT  
CORRECT  
b
a
Troubleshooting Guide:  
PUMP  
CLIP  
Problem  
1. Cannot pump bike.  
Cause  
Solution  
1. Air intake on bike and/or  
pump nozzle is clogged.  
1. Use a toothpick to gently clean  
dirt/foreign material out of the air  
intake/pump nozzle.  
IMPORTANT: It will take 25 pumps to pressurize your bike. Pull the pump  
handle ALL THE WAY up and push it ALL THE WAY down to complete  
each of the 25 pumps. Incorrect pumping will result in lower than expected  
performance. FOR SAFE USE, DO NOT EXCEED 25 PUMPS.  
2. Engine will not start.  
2A. No air in bike.  
2A. Pump up bike as detailed in  
section B above.  
2B. Did not push bike along  
ground to start engine.  
2B. Give bike a firm push along the  
ground to start the engine.  
2C. Piston is at the back of the 2C.Rotate rear tire until piston  
window. in this position, the air moves to the front of the window.  
will leak out of the toy and the  
C. STARTING YOUR BIKE:  
c
1. Set the bike on a long flat  
engine will not start.  
surface.  
3. Bike will not go straight.  
3A. Wheels are turned.  
3A. Be sure to straighten the front  
and rear wheels before releasing  
the bike.  
2. Straighten the front and  
rear wheels.  
3B. You are not guiding  
the bike for 1-2 feet before  
releasing.  
3B. Be sure to guide the bike with  
your hand for 1-2 feet before  
releasing, as explained in C3 above.  
3. Give the bike a firm push  
forward and continue to  
guide the bike on a straight  
path for 1-2 feet before  
releasing. (c).  
4. Bike will not perform a  
pop-a-wheelie.  
4. Wheelie bar is not down.  
4. Lower wheelie bar into position  
as explained in D2 above.  
IMPORTANT: It is important to guide the bike on a straight path for  
1-2 feet after the engine starts. This is to stabilize the bike and continue it  
on a straight course.  
TIP: If you are having trouble making the bike go straight without  
falling over, try using the wheelie bar. The wheelie bar helps to  
balance the bike. This is similar to training wheels on a bicycle.  
Note: With practice, your runs will become straighter and longer  
and you will no longer need the assistance of the wheelie bar.  
Spin Master Toys,  
AIR HOGS® is a registered trademark of Spin Master Toys™.  
All rights reserved.  
450 Front Street West, Toronto,  
Ontario, Canada M5V 1B6  
Telephone: 1-800-622-8339  
AIR HOGS® MOTOCROSS BIKE © 2002 Spin Master Toys.  
All rights reserved.  
43020 ENG REV 1  
 

Snapper Brush Cutter SST BC User Manual
Snapper Dust Collector TP 100 200 User Manual
Sony Camcorder XCD SX910UV User Manual
Sony Camera Lens VCL 2030S User Manual
Sony Microcassette Recorder ICD B120 User Manual
Sony TV Mount MB 502B User Manual
Sterling Plumbing Musical Table scc2 User Manual
Suzuki Musical Instrument Corp Electronic Keyboard HP 97 User Manual
SVA Flat Panel Television HD4218P User Manual
Swann DVR SW242 2LP User Manual