Soleus Air Water Dispenser WA1 02 21 User Manual

Aqua Sub  
Easy Load Water Cooler  
Model No: WA1-02-21  
3092402  
WA1-02-21  
© 2008 Soleus Air International  
 
WARNING: This water cooler is for use on 120 volt  
outlets only. The cord has a plug as shown in A. An  
adapter as shown in C is available for connecting three-  
blade grounding-type plugs to two-slot receptacles. The  
grounding lug extending from the adapter must be con-  
nected to a permanent ground such as a properly  
grounded outlet box. The adapter should not be used if a  
three-slot grounded receptacle is available.  
DO NOT DEFEAT THE SAFETY PURPOSE OF THE  
GROUNDED PLUG.  
TECHNICAL SPECIFICATIONS  
Model  
WA1-02-21  
115V, 60Hz  
6.0 Amps, 580 Watts  
R134a, 37g  
Power Supply  
Electrical Rating  
Refrigerant and Quantity  
Design Pressure (High Side)  
188psig  
Design Pressure (Low Side)  
Dimensions  
88psig  
13.54"W x 17.2"D x 42" H  
3
 
PRODUCT DIAGRAM  
Power Switch  
Located on back; used to power on/off the  
unit  
Reset Button  
Located on back; press to restart the unit after  
Replacing the water bottle  
Indicator Panel  
Built-in Handle  
One located on each side  
Cold Water Dispenser  
Blue Handle  
Hot Water Dispenser  
Red Handle , includes child safety faucet.  
Squeeze two handles together and press down  
to operate  
Drip Tray  
Water Bottle Cap with Hose  
Lower Cabinet Door  
Water Bottle  
(Not included)  
Bottle Tray  
4
 
UNPACKING THE WATER COOLER  
1. Cut and remove the straps from the box. DO NOT turn the box upside down, or lay it on its  
side. The bottom of the box is separate from the top section. Lift straight up on the top box  
section to remove the top box section. Remove the Styrofoam packaging and plastic bag.  
Lift the water cooler off the bottom of the box. Wipe it clean if necessary.  
2. Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not  
be close to direct sunlight or other source of heat.  
3. It is best to place the water cooler in an area with good air circulation. Make sure there is at  
least 4 inches (10cm) of space between the back of your water cooler and the wall. Keep a  
minimum distance of 2 inches (5cm) on each side of your water cooler.  
WARNING: The drain cap on the back of the unit may become loose during shipping. Fasten  
the drain cap tightly before you start to operate the unit. If the drain cap is loose, the unit may  
leak and cause floor damage.  
PREPARING THE WATER COOLER FOR USE  
The Aqua Sub is different from a traditional water cooler. The water bottle does not need to be  
placed upside down on the top of the unit. The water bottle is placed in the lower cabinet of the  
unit, and then a pump draws the water up to the dispenser.  
Much like a new refrigerator with an ice maker or water dispenser, it is recommended to  
run 1 or 2 water bottles full of water through the system before use.  
Figure 1  
Figure 2  
5
 
1. Make sure the water dispenser is not plugged into an electrical out-  
let.  
2. Open the door of the lower cabinet and pull the tray out from the  
cabinet.  
3. Place a full water bottle on the tray. Remove the plastic cover over  
the mouth of the water bottle.  
4. Put the hose inside the water bottle and place the water bottle cap  
firmly over the mouth of the water bottle. Figure 1)  
5. Attach the hose to the water cooler by pressing in on the knob of the  
hose cap and sliding over the connector at the top of the cabinet.  
Figure 2)  
6. Push the tray inside the cabinet and close the lower cabinet door.  
7. Plug the water cooler into a grounded power outlet and turn on the  
power switch located on the back.  
8. The unit will start to operate, but you should wait at least half an  
hour before using the water cooler.  
NOTE: If there is not a secure connection between the hose cap and the connector on the water cooler,  
the water pump will operate but the water cooler will not dispense water. Make sure the hose is con-  
nected to the water cooler correctly.  
NOTE: Please wait until the water pump stops running before using the unit. If the water tank is not full, no  
water will dispense from the cold water faucet and the hot water faucet.  
NOTE: The second time the water bottle is changed after the light on the front panel is on, switch RESET to  
OFF for 3 seconds.  
6
 
OPERATION  
After the water bottle has been connected to the water cooler, the unit is ready for use. Turn the power switch  
on the back of the unit to ON. The water cooler will start running. First the unit will pump the water from the  
water bottle into the cooling and heating tanks, and then the unit’s compressor and heater will start to operate.  
The first time the water cooler is used, you will have to wait at least half an hour for hot and cold water.  
The Aqua Sub water cooler has 3 indicator lights on the front panel. When the Blue  
indicator light is on, the unit is in the process of cooling water inside the cooling tank.  
When the Yellow indicator light is on, the water cooler is heating water inside the heated  
water tank. When the Red indicator light on the front panel is on, there is no water left in  
the water bottle. The water bottle will need to be replaced. Replace the water bottle,  
and then press the RESET button located on the backside of the unit. The water cooler will  
work again and the indicator light will turn off.  
CLEANING & MAINTENANCE  
1. To avoid accidents, turn off and unplug the water cooler from the outlet before cleaning.  
2. A soft damp cloth may be used to clean the surface of the water cooler. When necessary, a mild deter-  
gent may be used. DO NOT use erosive chemical solvents to clean the unit, as this may damage the  
surface of the water cooler.  
3. DO NOT pour water on the exterior of the unit to avoid getting the internal electrical system damp. DO  
NOT immerse the unit in water when cleaning.  
4. The water bottle cap, hose, and drip tray may be washed in a dishwasher (top rack only).  
5. Keep the water cooler 6 inches (15cm) away from the wall so it can work properly. Make certain all  
ventilation openings are clear of obstruction.  
6. Do not damage the heating or cooling system, paying particular attention to the black condenser or heat  
radiator on the back of the water cooler.  
7. If you will not use the water cooler for a long period of time, please unplug the power cord and drain  
the water cooler. Drain the water from all faucets, then remove the drain cap on back and allow it to  
drain. Make certain the drain cap is fastened tightly when finished.  
7
 
TROUBLESHOOTING  
Please check the troubleshooting chart below. It includes several common problems, which you can correct  
at home, making a customer service call unnecessary.  
Problem  
Possible Cause  
Remedy  
Unit is unplugged.  
Main power supply is off.  
Unit does not dispense hot Damaged water dispenser  
Plug the power cord into an outlet.  
Reestablish main power supply.  
Replace the dispenser.  
and cold water.  
The water bottle cap is not attached Connect properly. There will be a  
properly to the connector on the  
water cooler.  
give when the hose cap slides prop-  
erly over the connector.  
Over consumption of cold water in Wait a moment for the water to  
a short time.  
cool.  
System Malfunction  
Contact Soleus Air for service  
The ventilation around the unit is  
insufficient.  
Space the unit from the wall by  
more than 15 cm.  
Unit does not dispense  
cold water.  
The temperature of water in the  
water bottle is too high. (When the Place the water bottle in a cool loca-  
bottle is exposed to direct sunlight tion out of direct sunlight.  
for a long time.)  
Over consumption of hot water in a Wait a moment for the water to  
Unit does not dispense hot  
water.  
short time.  
heat.  
System Malfunctions  
Contact Soleus Air for service  
Place the unit on a level, flat sur-  
face.  
The appliance is not level.  
Unit is noisy during opera-  
tion.  
Move the unit away from other ob-  
jects.  
Unit is touching other objects.  
The top portion of the faucet has  
become loose.  
Tighten the top threaded portion of  
the faucet.  
Water leaks from the fau-  
cet.  
Call the customer service telephone  
number to repair the faucet.  
Make sure the hose connector is  
properly connected. Contact Soleus  
Air Service if a water tank is leak-  
ing  
Tighten the drain cap. If the sealing  
silicon material inside the drain cap  
is torn or damaged, then replace  
with a new one.  
The faucet has been damaged.  
The Hose Connector is not con-  
nected properly or the inside hot or  
water tanks are leaking.  
Water is dripping out of  
the water cooler and onto  
the floor.  
The drain cap on the back is not  
fastened properly.  
Clean the hose in the dishwasher  
(top rack only) or let it soak in dish  
soap. The strange taste usually goes  
away after the first bottle has been  
used up.  
This is not uncommon with new  
The water being dispensed water coolers. Do not worry, this is  
has a strange taste.  
not dangerous to your health. This  
water cooler is FDA approved.  
8
 
WARRANTY  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air Water Cooler to be free of defects in material and  
workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of  
original retail purchase in the United States.  
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either repair or replace it, free of  
charge within a reasonable time after the unit is returned during the warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty Certificate along with a  
copy of the original purchase invoice.  
THIS WARRANTY DOES NOT COVER:  
Damage, accidental or otherwise, to the unit while in the possession of a consumer not caused by a defect in  
material or workmanship.  
Damage caused by consumer misuse, tampering, or failure to follow the care and special handling provisions  
in the instructions. This includes dents, accidental or otherwise, to the base and head of the unit.  
Damage to the finish of the case, or other appearance parts caused by wear.  
Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus  
International Inc.  
Freight and Insurance cost for the warranty service.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO  
ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS INTERNATIONAL INC.  
DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT  
SHALL SOLEUS INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR  
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.  
This warranty covers only new products purchased from our authorized dealers or retailers. It does not cover used, sal-  
vaged, or refurbished products.  
As some states do not allow the limitation or exclusion of incidental or consequential damages, or do not allow  
limitation on implied warranties, the above limitations and exclusions may not apply to you. This warranty gives you  
specific legal rights, and you may also have other rights that vary from state to state.  
For Technical Support & Warranty Service  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
20035 E Walnut Dr. North  
City of Industry, CA 91789 USA  
9
 

Shure Automobile Parts a15HP User Manual
Silex technology Network Card SX 10WG User Manual
Socket Mobile Camera Accessories CF 10 100 User Manual
Sonos Stereo System ZP100 User Manual
Sony Portable Multimedia Player NWZE463 User Manual
Sony VCR SLV SX40EG User Manual
Star Manufacturing Griddle 724T User Manual
Sunbeam Blender PB7650 User Manual
Sunbeam Microwave Oven SMW610 User Manual
Tangent Audio Stereo System FM AM Radio Clock User Manual